waross based on what you posted I'm thinking my best approach would be to add a 240 VFD to this in order to change the single phase to three phase. I suspect this might provide enough power to turn the load. I will begin with the tumbler empty than add to it until either I have a full load or it...
Would adding a reduction gear to drop the gear ratio, such as GBPN-0403-160-AA171-197 from Anaheim automation which has a 160:1 ratio work to increase the torque? As for the drive if I'm understanding the information correctly it seems to be the type of thing that would work just need to try to...
I would like to run this motor using 240 Volt single phase. I am thinking that I would require a VFD to go from single phase to three phase power but not sure about the voltage difference. The motor is going to be used to turn a tumbler which will have very low rotational RPM, between 15 and 25...
