Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by BL1

  1. BL1

    Copper Wire Braiding vs. Stranded Wire

    Hi all, There is a question that has arisen at my work place concerning frame grounding of 110v/220v frames,cabinets,plc racks,and such like. Is it more reasonable to use wire braid for framing or continue with stranded wire.There seems to be a benefit to braid because of lightning dissipation...
  2. BL1

    Auto-transformer starting

    We are about to install a 10ft fan with a 2500hp motor.We are going to use an auto-transformer (5000kva) to supply the motor.This will be used to ventilate a large mine with multiple coal seams.We will eventually add another fan of the same.My question: are there any draw backs to using...
  3. BL1

    motor failure

    Just a thought.Just wondering actually.Nema design letter and the service factor designation? Were those on the name plate as well?
  4. BL1

    Spline Balls on Transmission Lines

    SUBTECH---WE'RE TALKING OLD SCHOOL AND GETTING THE JOB DONE.SUPERB.WORDS TO ENGINEER BY.A STAR--THANKS.
  5. BL1

    Mine ground systems

    TULUM, THIS MIGHT HELP.CHECK OUT MSHA HANDBOOK ON THEIR WEBSITE AT WWW.MSHA.GOV.UNDER SEARCH USE PH93-V-7.THIS SHOULD BE THEIR ELECTRICAL INSPECTORS GUIDE LINES.HOPE THIS IS OF SOME BENEFIT TO YOU.BEST REGARDS. BL1(MINING)
  6. BL1

    auto-transformer for grounding purposes

    My question is:can an auto-transformer (not a zig-zag) derive a netural for a high resistance grounded system? If so,what are the limitations and if not,why? Thanks in advance for any ideas or thoughts on this subject.
See more

Part and Inventory Search

Back
Top Bottom