Diamondjim, Using the hob/rack method of machining. Is about the same as some of the procedures I have located in hobby machinist magazines.
What I am looking for is a program, that I can input Pitch, Angle of tooth, OD of the blank, and tooth depth, all available from stock catalogs.
OD...
STEVEENG, I HAD A COMPUTER CRASH, AND LOST IT, BUT I ALSO HAD NO PROGRAM THAT WOULD OPEN IT. WOULD YOU RESEND IT TO WANLIKER@AOL.COM, THANK YOU. I WILL TRY TO FIND SOMETHING TO OPEN IT WITH. ANY SUGGESTIONS ON THAT?
BILLCCED
DIAMONDJIM, THIS IS FOR THE REGULAR TIMING BELTS SUCH AS THE XL...
Can anyone here provide me with a link as to where I can get software for designing Timing Pulley's?
I would like to input: pitch, angle of tooth, depth of cut, and number of teeth. All of these parameters are available from catalogs.
And get out: blank OD, Depth of cut? Width of cutting tool...
