no not hot melt glue. that will be rigid and just peel off the board.
use an RTV type of glue. make sure there is some RTV attached to the wire insulation AND the circuit board, or whatever you are soldering this wire too.
then, just as important, make sure the wire has some stress relief in...
yes. you can make a variable frequency motor drive, and pair it with a speed controllable motor.
such as:
https://www.groschopp.com/whitepaper/how-to-use-vfd-variable-frequency-drive/
in bigger applications, this is fairly common. i have a small milling machine that controls the spindle speed...
it looks like the crystal circuit has more than one frequency resonance, and the total circuit is actually oscillating at two frequencies simultaneously. have you looked at the wave form with an AC coupled spectrum analyzer.
you might have to add L-C circuits to suppress the unwanted oscillation
so can you stiffen the area around the punched hole? maybe have a small picture frame of copper around the hole? Glue on a 5 mil picture frame of G10 board?
An SCR will also act as the thyristor mentioned above.
on the SCR gate, it you put a voltage there above the trigger level, DC current will flow thru the SCR, and will continue to do so even if the gate voltage goes back to zero.
your big problem is that this trigger voltage is between zero and...
use an emi filter. Shunt capacitor, series inductor, shunt capacitor right at the power supply
hook an oscilloscope to the "DC" output, and record what frequency the noise is at. then design a filter to stop it
www.MaguffinMicrowave.com
Maguffin Microwave wireless design consulting
well, I would use a circular polarized antenna (probably in round waveguide), then convert it back to single mode waveguide, and then hang a schottky diode detector across the E field direction. Schottky diodes are pretty fast, if loaded with a resistive load on the bias port...
since it was a MA, USA firm, it is possible it was approved for use in the USA. If so there might be a manual and/or test report on file at the FCC. Look for an FCC ID number on the equipment. If you find it..u are in luck. Enter it here...
THEN, there are the board issues. Sounds like you have an open PCB--i.e. no shielding. While many systems can not afford the cost...it sounds like you are working more on a military type system where cost is less important. Try putting your PCB into a channelized metal housing. By...
Well, reading this post with some hilarity, there are a number of potential issues you are facing.
1st, you need to do a sub-system level analysis of your block diagram. Sounds like you have some sort of mixer as an upconverter, and possibly amplifiers or filters. 1st u need to look at the...
you could slip some of this stuff over the wires. Probably good for another 10-15 dB.
http://www.arc-tech.com/cables.php
www.MaguffinMicrowave.com
Maguffin Microwave wireless design consulting
