SW 2006 SP4.1, Sometimes we will open an assembly and it will give a message saying that certain configs couldn't be found, something to that extent.. Then a M6 x 20 all of a sudden will turn into a M16 x 50 or something... Is this a toolbox issue? Has it been fixed for 2007?
Go Honda!
I have a drawing of a part, that cannot show an alternate position, it's not a section, broken or detail view. I created a new drawing, dragged the part on it and saw the problem... Any suggestions?
Go Honda!
I have evrything turned on in every menu. I've re-created the whole assembly, THAT fixed the problem... ha ha, I wonder if this is just a glitch of some sort.. Does anyone know if there is a later service pack release than 4.1??
Go Honda!
2006 SP 4.1, In an assembly with other assemblies in it, I right click on a part and all that is available is show and show all. I can open one of the other sub-assemblies and the hide function is there... Also, on the assembly tool bar if I click on a part, the hide/show icon is already...
Yes I did, then broke refs and fully defined the sketch.. I think this dog has been beaten enough, I just wanted to know why mine was fine and everyone else had errors/warnings.. Still confused as to why but I have to move on.. wasted almost 20 hours on this now...
Go Honda!
Easy now, I'm trying to make energy over here... I've uploaded the "tower" were this part is used..
http://quick.dropfiles.net/343792
password b18c5rjdm
Go Honda!
no, I work for the US Government. funny though, I needed a laugh. how did the holes stay there, I can ctrl-q the heck out of this thing and it stays the same...
Go Honda!
I never check anything in to PDM with errors at all, so now that the part has been loaded into several machines, what is the problem with my machine? The errors that you guys listed are the same ones on the other machine here...
Go Honda!
