Thanks, it would defiantly be a bad day if the pipe broke, but I think we have time to weigh our options. I like the articulated block idea and I'm looking into it.
A large water main has become partiality exposed in a good sized creek due to bank erosion and channel movement. Its happened over the last 40 years since it was installed. I’m looking at ways to add cover to protect the pipe and stabilize it. Riprap, sheet piles and gabions have all been...
In my preliminary designs I also use manning's formula, I match crowns, and I try to stay over 1% with my pipes. I've also found that it almost always works when I run the HGL.
Our Design criteria specifically says no pressurize pipes (unless we have a really really good reason), so we do it...
Thanks cvg. do you think this requirement was developed only to mitigate the effects of debris and blockages or could there be some other issues it relates to? Just trying to understand the motivations and thinking behind the guidance. Our local drainage manual is under revision and this...
Many jurisdictions have a storm sewer system design requirement that the calculated energy grade line be below the rims of manholes and the throats of inlets. This is in additional to the requirement that the hydraulic grade line be 2' (or something close to that) below rims and throats, which...
I have several spring cans that I will need to verify the hot setting, trouble is that when its hot, I can't get anywhere near the pipe or the cans to look at them. Any ideas how to do this?...Looking for an alternate to setting up cameras. I can cool them back down later and check what...
According "The Electrical world, Volume 32, page 72", dated 1898 (found on Google books), Its not practical to seal manhole lids watertight when they are exposed to vibration and impacts of street traffic. So the outer manhole is intended to take the impacts of traffic, while the inner manhole...
Thanks Bimr,
I do know exactly whats under the lids, deep concrete vaults containing cables and splices and sump pumps. See, what I'm trying to figure out is why the original designer used double manhole lids. You can order a watertight and locking frame with a single cover. After doing more...
There's actually a number of manholes of varying size and depth containing a number of different power and control cables, they're located around a power plant. The old drawings show a detail for the ring and "double" cover (an inner cover and outer cover). The detail references a "Flockhart...
There is an electrical manhole with a cover frame designed for an inner and outer solid cover, one below the other. The inner cover is locking. Does anyone know what the purpose of using the double manholes?
The new units are pretty massive, they weight about 550 Kips a piece. I've come up with 7 ksf max contact pressure applied on one side of the foundation, and less than 1 ksf on the other. Its about 3.5 ksf with the current arrangement (evenly distributed).
We have a couple of 30-year transformers with pads that are 4.5' deep, 10'long and x 20' wide. We are replacing the transformers, but want to reuse the pads. The new transformers are about 20% heavier, and has its center or gravity shifted off the center-line in the short direction of the...
Since Civil 3d gives you the total cut / fill volumes…what you need to know is the volume of cut from 0”* to -18”.
You could do this by generating cut/fill ticks, drawing polylines around the cut regions to get the area, estimating the average depth of cut (with 18” as your lower bound)...
