Interesting information. Since everyone sees this as a airgun I resized my syringe and needle to be comparable to what hydtools linked to. Nice link by the way. Never seen that before.
If my calculations are correct I come up with:
Cylinder diameter: 0.22 inches
Cylinder length: 16...
I should be able to get 600 psi from the cylinder or piston in a tenth of a second using the proper motor. But I am unsure the proper way to calculate the actual required pressure and cfm required. I would rather not use a sledge if a small ball peen will do.
I plan on using a syringe that has a diameter of 1" and a 2.5" stroke. The needle is 0.25 diameter and 10" long. The syringe pushes air not liquid. I have a 2 gram payload in the needle at the junction of the syringe and the needle. how do I figure out how much force and speed to apply to the...
I need a chart or explanaton of how to figure the amount of change in hastalloy and 316 stainless steel from temps of -20f to +70f.
Thanks in advance,
Donny
www.whiterivermfg.com
Have a Fanuc GMF L-100 Robot. I need a exploded view of the mechanical side of it. The arm and wrists mainly. If someone has a manual laying around could you scan a page or two and send it to me. Or if you have a old manual you don't need let me know what i can do to talk you out of it.
Donny...
I have a GMF L-100 with RH Control that i would like to program with g-code from my CAM software. Is there a convertor or post processor that will alow me to get my g-code into the RH contol's Karel language?
Donny
www.whiterivermfg.com
